Remember the ‘Pin’ corresponding to your network in the scan results, this will be needed for later.Ĩ] In the previous area ‘Connect using Jumpstart’, hit the ‘Start JumpStart’ button.ĩ] Under ‘What do you want to do?’, select ‘Join a wireless network’ and hit ‘Next’ġ0] Under ‘Which setup method do you want to use?’, select “Enter the PIN from my access point” and enter the PIN next to your network in the scan section back in the previous scan results.ġ1] Finally, select the targeted network from before and hit ‘Next’.Now you’re happily connected to that WiFi network you just penetrated. Don’t open it, just select the ‘Jumpstart’ folder and click ‘OK’)ĥ] In the area ‘Show default pin’, select ‘All networks’ isntead of ‘Only known networks’.ħ] Select the network you wish to penetrate. (By default, it installs in C:Program Files (x86)Jumpstart. In the area that says ‘Connect using JumpStart’, hit ‘Browse’ to select the location of where you installed JumpStart in the previous set-up steps.
Hit the ‘Scan’ button now.Ĥ] After it completes the scan, go over to the ‘Wps’ tab. It’ll be in Spanish, so go to the far right tab and select ‘English’ in between the other two options.Your programs are set up and ready to go, now begin the processģ] In the ‘Networks’ tab, select the network adapter you wish to use. 1] Download and install JumpStart, WinPcap, and DumpperĢ] Open Dumpper.
0 kommentar(er)
